Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal.

Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal.

Brodit

713101

Availability: Niet op voorraad, levertijd 2 tot 10 werkdagen

Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal.
€ 114,95 € 95,00 Excl. BTW
Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal.

With tilt swivel.

Use an active holder for your Panasonic while driving and you will always have a freshly charged battery! The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Charging via pogo plug. Professional installation recommended.

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the unit into place in the holder, and to take it with you when leaving the car.

Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

Width: 213 mm
Height: 155 mm
Depth: 50 mm
Volume: 1651 cm³
Weight: 442 g

Accessoiremerk Brodit
Type Tablet
Aansluiting Nee
Pedestal lengte Nee
Pedestal hoek ° t.b.v. houder Nee
Pedestal eigenschap Nee
Houder professional Nee
Toestel connector Nee
Toestel houder dikte Nee
Type Nee
Toestel houder breedte Nee
Pedestal kleur Nee
Toestel houder op- en/of afsluitbaar Nee
Productinfo Professionele houder met draaimechaniek voor uw smartphone, navigatiesysteem of tablet. Hinderlijke reflectie behoort tot het verleden door het aanpassen van de invalshoek
Veiligheid (productinfo) Deze Brodit houder biedt extra veiligheid, het voorkomt dat uw toestel bij een plotselinge manoeuvre een projectiel wordt of onder uw pedalen komt..
Productinstallatie Monteer de houder op een ProClip in uw voertuig. Een uitgebreide montagehandleiding zit in de productverpakking
Product geschikt voor info Bij het tabblad Compatibility List checkt u of smartphone, navigatiesysteem of tablet geschikt is voor deze houder
  • Panasonic Toughpad FZ-L1